Removal

PARKING BRAKE: PARKING BRAKE CABLE: REMOVAL

REMOVAL

1. DISCONNECT BATTERY NEGATIVE TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT SEAT ASSEMBLY
HINT: Refer to the instructions for Removal of the front seat assembly Removal.

3. REMOVE CONSOLE UPPER PANEL GARNISH FRONT Removal
4. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal
5. REMOVE INSTRUMENT PANEL FINISH LH PANEL END Removal
6. REMOVE INSTRUMENT PANEL FINISH RH PANEL END Removal
7. REMOVE CONSOLE BOX PLATE (for 4WD) Removal
8. REMOVE CONSOLE BOX REGISTER ASSEMBLY (for 4WD) Removal
9. REMOVE CONSOLE BOX Removal
10. REMOVE FRONT FLOOR BRACE CENTER (for 2GR-FSE) Removal
11. DISCONNECT HEATED OXYGEN SENSOR (for 2GR-FSE) Removal
12. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2GR-FSE) Removal
13. REMOVE FRONT FLOOR HEAT NO.1 INSULATOR (for 2GR-FSE) Removal
14. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 2GR-FSE) Removal
15. REMOVE FRONT FLOOR COVER CENTER LH (for 1UR-FSE)
16. REMOVE FRONT FLOOR COVER CENTER RH (for 1UR-FSE)
17. REMOVE REAR NO. 1 FLOOR PANEL BRACE (for 1UR-FSE) Removal
18. REMOVE FRONT CENTER FLOOR BRACE (for 1UR-FSE) Removal
19. DISCONNECT HEATED OXYGEN SENSOR (for 1UR-FSE) Removal
20. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 1UR-FSE) Removal
21. REMOVE FRONT FLOOR HEAT NO. 1 INSULATOR (for 1UR-FSE) Removal
22. REMOVE AIR GUIDE PLATE OUTSIDE RH (for 1UR-FSE) Removal
23. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 1UR-FSE) Removal
24. REMOVE DIFFERENTIAL SUPPORT NO.2 PROTECTOR Removal
25. REMOVE REAR WHEEL
26. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Disassembly
27. REMOVE REAR DISC Disassembly
28. REMOVE PARKING BRAKE SHOE RETURN NO.2 SPRING Disassembly
29. REMOVE PARKING BRAKE SHOE RETURN NO.1 SPRING Disassembly
30. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET Disassembly
31. REMOVE PARKING BRAKE NO.1 SHOE ASSEMBLY Disassembly
32. REMOVE PARKING BRAKE NO.2 SHOE ASSEMBLY Disassembly
33. REMOVE PARKING BRAKE SHOE LEVER
34. REMOVE PARKING BRAKE NO.3 CABLE ASSEMBLY
(a) Remove the 3 bolts and disengage the 2 clamps and parking brake No.3 cable assembly.
(b) Separate the parking brake No.3 cable assembly from the parking brake equalizer.

(d) Remove the 2 cable support brackets from the parking brake No.3 cable assembly.