Installation

2GR-FE ENGINE MECHANICAL: ENGINE REAR OIL SEAL:

INSTALLATION

1. INSTALL ENGINE REAR OIL SEAL





(a) Apply MP grease to a new oil seal lip.
(b) Using SST and a hammer, tap in the oil seal.
SST: 09223-15030
SST: 09950-70010
09951-07150
Oil seal tap in depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY





(a) Using SST, hold the crankshaft.
SST: 09213-70011
09213-70020
SST: 09330-00021





(b) Apply adhesive to 2 or 3 threads of the mounting bolt end.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent





(c) Install the front spacer, drive plate and rear spacer on the crankshaft.
(d) Install and tighten the 8 mounting bolts uniformly in several steps.
Torque: 83 Nm (850 kgf-cm, 61 ft-lbf)
3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
HINT: Installation.