Installation

BRAKE: BRAKE MASTER CYLINDER:

INSTALLATION

1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY





(a) Install a new O-ring, the brake master cylinder sub-assembly and the front brake tube way with the 2 nuts.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)





(b) Temporarily tighten the 6 brake lines and connect the connector.





(c) Using SST, fully tighten the 6 brake lines
SST: 09023-00101
without SST - Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
with SST - Torque: 14 Nm (143 kgf-cm, 10 ft-lbf)
- Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
- This torque value is effective when SST is parallel to a torque wrench.

2. FILL RESERVOIR WITH BRAKE FLUID Service and Repair
3. BLEED MASTER CYLINDER Service and Repair
4. BLEED BRAKE LINE Service and Repair
5. BLEED BRAKE ACTUATOR ASSEMBLY Service and Repair
6. INSPECT FLUID LEVEL IN RESERVOIR Service and Repair
7. INSPECT FOR BRAKE FLUID LEAK
8. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Installation
9. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
10. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
11. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
12. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation
13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
14. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
15. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
16. INSTALL FRONT SUSPENSION UPPER CENTER BRACE





(a) Install the front suspension upper center brace with the 4 nuts.
Torque: 85 Nm (867 kgf-cm, 63 ft-lbf)
17. INSTALL ENGINE ROOM SIDE COVER LH Installation
18. INSTALL ENGINE ROOM SIDE COVER RH Installation
19. INSTALL HOOD HINGE COVER (for LH Side) Installation
20. INSTALL HOOD HINGE COVER (for RH Side) Installation
21. INSTALL COOL AIR INTAKE DUCT SEAL Installation