Removal

PARK ASSIST / MONITORING: CLEARANCE WARNING BUZZER (for Front Side): REMOVAL

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

6. REMOVE NO. 3 BOX PANEL Removal

7. REMOVE REAR CONSOLE PANEL UPPER Removal

8. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER Removal

9. REMOVE RADIO RECEIVER ASSEMBLY Removal

10. REMOVE NO. 1 CLEARANCE WARNING BUZZER






(a) Disconnect the connector.
(b) Detach the clamp and remove the clearance warning buzzer.