Removal

OTHER SYSTEM: CLOCK: REMOVAL

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

6. REMOVE NO. 3 BOX PANEL Removal

7. REMOVE REAR CONSOLE PANEL UPPER Removal

8. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER Removal

9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET Removal

10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY WITH BRACKET (w/o Multi-display) Removal

11. REMOVE DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET (w/ Multi-display) Removal







12. REMOVE CLOCK ASSEMBLY
(a) Using a screwdriver, detach the 2 claws and remove the clock.
HINT: Tape the screwdriver tip before use.