Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY:

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Install the curtain shield airbag assembly with the 2 clips and 9 new bolts.
Torque: 11 Nm (110 kgf-cm, 8 ft-lbf)





NOTE: Do not twist the curtain shield airbag assembly when installing it.

(b) Connect the connector.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
HINT: Some systems need initialization after reconnecting the cable to negative battery terminal.

5. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.