How To Proceed With Troubleshooting

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (w/ VDIM):

HOW TO PROCEED WITH TROUBLESHOOTING
HINT:
- The vehicle stability control system troubleshooting procedures are based on the premise that the multiplex communication system is operating normally. Check the multiplex communication system first before troubleshooting the vehicle stability control system.
- Use Techstream at steps 3, 7 and 10.

1. VEHICLE BROUGHT TO WORKSHOP
NEXT -- Continue to next step.
2. CUSTOMER PROBLEM ANALYSIS
(a) Interview and confirm the trouble How To Proceed With Troubleshooting.
NEXT -- Continue to next step.
3. CHECK DTC AND FREEZE FRAME DATA
(a) Check and record a DTC and Freeze Frame Data.
(b) Clear the DTC and Freeze Frame Data Vehicle Stability Control System (w/ VDIM).
(c) Reconfirm the DTC.
(1) Reconfirm the DTC based on the recorded DTC and Freeze Frame Data Vehicle Stability Control System (w/ VDIM).
HINT: If any of the DTC U0100/65, U0123/62, U0124/95, and U0126/63 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit Check For Intermittent Problems.

Result:






B -- GO TO STEP 5
C -- GO TO STEP 6
A -- Continue to next step.
4. DIAGNOSTIC TROUBLE CODE CHART
NEXT -- GO TO STEP 7
5. SYMPTOM SIMULATION
NEXT -- Continue to next step.
6. PROBLEM SYMPTOMS TABLE
NEXT -- Continue to next step.
7. CIRCUIT INSPECTION
NEXT -- Continue to next step.
8. IDENTIFICATION OF PROBLEM
NEXT -- Continue to next step.
9. REPAIR OR REPLACEMENT
NEXT -- Continue to next step.
10. CONFIRMATION TEST
NEXT -- END