Removal

EXTERIOR: REAR BUMPER:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM COVER (w/ Clearance Sonar System)
3. REMOVE DECK SIDE TRIM BOX LH (w/ Clearance Sonar System)
4. REMOVE DECK SIDE TRIM BOX RH (w/ Clearance Sonar System)
5. REMOVE ROPE HOOK ASSEMBLY (w/ Clearance Sonar System)






(a) Remove the 3 bolts and 3 rope hook assemblies.
6. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER (w/ Clearance Sonar System)
(a) Remove the triangle reflector.






(b) Using a clip remover, remove the 3 clips.
(c) Disengage the 4 clips and remove the rear luggage compartment trim cover.
7. REMOVE NO. 2 ROOM LIGHT ASSEMBLY (w/ Clearance Sonar System)






(a) Disengage the claw and disconnect the No. 2 room light assembly.
(b) Disconnect the connector and remove the No. 2 room light assembly.
8. REMOVE ROPE HOOK (w/ Clearance Sonar System)






(a) Remove the 2 rope hooks.
9. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/ Clearance Sonar System)






(a) Remove the 3 luggage compartment trim hooks as shown in the illustration.






(b) Using a clip remover, remove the 2 clips.
(c) Disengage the 4 claws and remove the front luggage compartment trim cover.
10. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/ Clearance Sonar System)






(a) Remove the screw and No. 1 luggage compartment trim hook.
11. REMOVE SIDE LUGGAGE COMPARTMENT TRIM COVER LH (w/ Clearance Sonar System)






(a) Using a clip remover, remove the 3 clips and side luggage compartment trim cover LH.
12. DISCONNECT NO. 3 LUGGAGE ROOM WIRE (w/ Clearance Sonar System)






(a) Disconnect the No. 3 luggage room wire connector.
(b) Disengage the grommet.
13. REMOVE NO. 1 REAR BUMPER PLATE






(a) Using a screwdriver, disengage the 2 claws and remove the No.1 rear bumper plate.
- Tape the screwdriver tip before use.
- Use the same procedures for the RH side and LH side.

14. REMOVE REAR BUMPER ASSEMBLY






(a) Put protective tape around the rear bumper assembly.
(b) Using a clip remover, remove the 2 clips.
(c) Remove the 6 screws and 2 rear bumper seal brackets.






(d) Disengage the 6 claws and disconnect the rear bumper assembly as shown in the illustration.
HINT: Use the same procedures for the RH side and LH side.





(e) Disengage the 4 claws and remove the rear bumper assembly as shown in the illustration.