Installation

AUDIO / VISUAL: AMPLIFIER ANTENNA:

INSTALLATION

1. INSTALL AMPLIFIER ANTENNA ASSEMBLY






(a) Engage the clip as shown in the illustration to temporarily install the amplifier antenna assembly.
- Clean the antenna conductors on the rear window with white gasoline where the contact terminals will touch.
- When installing a new amplifier antenna assembly, do not remove the protective cover until immediately before installation.
- Do not touch the contact terminals.





(b) Install the 2 nuts and amplifier antenna assembly.
Torque: 14 Nm (143 kgf-cm, 10 ft-lbf)
(c) Connect the connector.
(d) Engage the clamp.
2. INSTALL ROOF HEADLINING ASSEMBLY Installation

HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY".

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal Repair Instruction - Initialization.

5. INSPECT SRS WARNING LIGHT Diagnosis System