DTC 80-10

NAVIGATION SYSTEM: 58-10: Gyro Error

DTC 58-10 - Gyro Error

DTC 80-10 - Gyro Error

DESCRIPTION





INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.

PROCEDURE

1. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)





(a) Enter the "Navigation Check" mode (Vehicle Sensors) Navigation Check Mode.
(b) Check the gyro voltage.
Standard voltage:
0.1 to 4.5 V
NG -- REPLACE NAVIGATION ECU
OK -- Continue to next step.
2. CLEAR DTC
(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.
NEXT -- Continue to next step.
3. RECHECK DTC
(a) Recheck for DTCs and check if the same trouble occurs again.
HINT: If DTCs are detected frequently, replace the navigation ECU.

OK:
Malfunction disappears.
NG -- REPLACE NAVIGATION ECU
OK -- END