DTC 5C-40

NAVIGATION SYSTEM: 5C-40: Camera Picture Error

DTC 5C-40 - Camera Picture Error

DESCRIPTION





WIRING DIAGRAM





INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY - TELEVISION CAMERA ASSEMBLY)
(a) Disconnect the J51 connector from the multi-display.
(b) Disconnect the Q43 connector from the television camera assembly.





(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. INSPECT MULTI-DISPLAY
(a) Reconnect the multi-display J51 connector.





(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:






NG -- REPLACE MULTI-DISPLAY
OK -- REPLACE TELEVISION CAMERA ASSEMBLY