B2002

PRE-COLLISION SYSTEM: B2002: Open in Seat Belt Motor RH Circuit

DTC B2002 - Open in Seat Belt Motor RH Circuit

DESCRIPTION

The seat belt control ECU receives information from the distance control ECU using CAN communication and tightens the seat by operating the motor in the front seat outer belt assembly RH.
CAUTION: The pretensioner is built into the front seat outer belt assembly RH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.





WIRING DIAGRAM





INSPECTION PROCEDURE
NOTE: When the seat belt control ECU is replaced with a new one, INITIALIZATION must be performed. Pre-Collision System

PROCEDURE

1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY RH





(a) Disconnect the P8 connector of the front seat outer belt assembly RH.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY RH
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY RH - SEAT BELT CONTROL ECU)





(a) Disconnect the negative (-) battery terminal.
(b) Disconnect the Q38 connector of the seat belt control ECU.
(c) Using a service wire, connect P8-1 and P8-2 of the connector on the front seat outer belt assembly RH side.
NOTE: Do not forcibly insert the service wire into the terminals of the connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE SEAT BELT CONTROL ECU