Removal

1UR-FSE FUEL: FUEL PUMP: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE
(a) Discharge fuel system pressure Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

4. REMOVE ROOM NO. 3 PARTITION PAD

(a) Remove the clip and room partition pad.
5. REMOVE REAR FLOOR NO. 2 SERVICE HOLE COVER

(a) Remove the service hole cover and disconnect the fuel pump connector.
6. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
(a) Disconnect the fuel pump tube sub-assembly and return tube.

(1) Remove the 2 tube joint clips and fuel tubes.
NOTICE:

- Remove any dirt and foreign matter on the fuel tube joint before performing this work.
- Do not allow any scratches or foreign matter on the parts when disconnecting them, as the fuel tube joint has the O-rings that seal the plug.
- Perform this work by hand. Do not use any tools.
- Do not forcibly bend, twist or turn the nylon tube.
- Protect the disconnected parts by covering them with plastic bags and tape after disconnecting the fuel tubes.

(b) Using a 6 mm hexagon socket, set SST to the fuel pump gauge retainer.
SST: 09808-14020
09808-01410
09808-01420
09808-01430
NOTICE:
Do not use any other tools such as a screwdriver.
HINT:
Fit the tips of SST on the ribs of the retainer.

(d) Disconnect the fuel suction tube.
(e) Remove the fuel suction tube assembly from the fuel tank.
NOTICE:
- Make sure that the sender gauge arm does not bend.
- Do not damage the fuel suction tube.

(f) Remove the No. 1 fuel suction tube set gasket from the fuel tank.