Replacement

DIFFERENTIAL: REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL: REPLACEMENT

1. REMOVE REAR TIRE
2. DRAIN DIFFERENTIAL OIL
(a) Using a hexagon wrench (10mm), remove the filler plug and gasket.
(b) Using a hexagon wrench (10mm), remove the drain plug and gasket, and drain the oil.
(c) Install the differential drain plug and a new gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
3. REMOVE REAR DRIVE SHAFT
Removal
4. REMOVE REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL






(a) Using SST, remove the oil seal.
SST: 09308-10010
5. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL






(a) Using SST and hammer, install a new oil seal.
SST: 09950-70010
09951-07150
SST: 09223-15030
Oil seal drive in depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
(b) Apply MP grease to the oil seal lip.
6. INSTALL REAR DRIVE SHAFT
Installation
7. ADD DIFFERENTIAL OIL Adjustments

8. INSPECT DIFFERENTIAL OIL Adjustments

9. INSTALL REAR TIRE
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
Rear Wheel Alignment
11. CHECK ABS SPEED SENSOR SIGNAL
(w/ Electronically Controlled Brake system: Test Mode Procedure)
(w/o Electronically Controlled Brake system: Test Mode Procedure)