Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY






(a) Connect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Install the driver side knee airbag assembly with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
2. INSTALL INSTRUMENT PANEL SAFETY NO.1 PAD SUB-ASSEMBLY Installation

3. INSTALL INSTRUMENT PANEL UNDER NO.1 COVER SUB-ASSEMBLY Installation

4. INSTALL INSTRUMENT SIDE PANEL Installation

5. INSTALL INSTRUMENT PANEL FINISH PANEL END Installation

6. INSTALL FRONT ASH RECEPTACLE ASSEMBLY Installation

7. INSTALL CONSOLE UPPER PANEL GARNISH FRONT Installation

8. INSTALL FRONT DOOR OPENING TRIM COVER Installation

9. INSTALL FRONT DOOR SCUFF PLATE Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION
12. INSPECT SRS WARNING LIGHT