Skid Control Buzzer Circuit

BRAKE CONTROL: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: Skid Control Buzzer Circuit

Skid Control Buzzer Circuit

DESCRIPTION

The skid control buzzer sounds while the accumulator pressure is abnormally low or an abnormality causing low fluid pressure occurs, and then the VSC is activated.

WIRING DIAGRAM





INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration Programming and Relearning.

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (SKID CONTROL BUZZER)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG) and turn the Techstream main switch on.
(c) Select the Active Test mode on the Techstream.

ABS / VSC / TRAC:





(d) Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the Techstream.
Result:





HINT:
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step Problem Symptoms Table.

B -- INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL)
A -- END
2. INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL)





(a) Disconnect the skid control buzzer connector.
(b) Turn the engine switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Voltage:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
3. INSPECT SKID CONTROL BUZZER





(a) Disconnect the skid control buzzer connector.
(b) Apply battery negative voltage to terminal 1, and battery positive voltage to terminal 2 of the skid control buzzer, and then check that the buzzer sounds.
OK:
Skid control buzzer sounds.
NG -- REPLACE SKID CONTROL BUZZER
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU TO SKID CONTROL BUZZER)





(a) Disconnect the skid control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. INSPECT SKID CONTROL ECU (GND TERMINAL)





(a) Disconnect the skid control ECU (A13, A15) connectors.
(b) Measure the resistance according to the value(s) in the table below.
Resistance:





HINT:
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part Problem Symptoms Table.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK -- REPLACE SKID CONTROL ECU