Installation

ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION

HINT:
A bolt without a torque specification is a standard bolt Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY





(a) Pass the cable into the engine room.
(b) Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.
(c) Pass the cable front side through the upper radiator support.
(d) Connect the clamps as shown in the illustration.









2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY






(a) Install the hood lock lever and connect the hood lock control cable.
(b) Attach the 2 claws.
3. INSTALL HOOD LOCK ASSEMBLY






(a) Apply MP grease to the sliding areas of the lock.






(b) Install the hood lock
(c) Install the 2 bolts and nut.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(d) Install a new cap.
(e) Connect the hood lock control cable.






4. INSTALL FRONT FENDER PROTECTOR UPPER LH
(a) Attach the 3 clips to install the protector.






5. INSTALL HOOD LOCK CONTROL CABLE COVER
(a) Attach the claw and install cable cover.
(b) Install the 3 screws.
6. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Cruise Control System) Installation

7. INSTALL FRONT BUMPER COVER Installation

8. INSTALL COOL AIR INTAKE DUCT SEAL Installation

9. INSTALL ENGINE ROOM SIDE COVER LH (for 2GR-FSE) Installation

10. INSTALL ENGINE ROOM SIDE COVER LH (for 1UR-FSE) Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. CHECK SRS WARNING LIGHT
(a) Check SRS warning light Diagnosis System.