DTC 2-1

CELLULAR COMMUNICATION: LEXUS LINK SYSTEM: 2-1: EEPROM Communication Error

DTC 2-1 - EEPROM Communication Error

DTC 2-2 - EEPROM Checksum Error

DESCRIPTION

These DTCs are output when an error occurs in the CPU of the mayday ECU.










INSPECTION PROCEDURE

PROCEDURE

1. RESET MAYDAY ECU
(a) Exit diagnosis mode and wait for 10 seconds.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for 1 minute.
(c) Reconnect the cable to the negative (-) battery terminal, and wait for 10 seconds.
(d) Turn the engine switch on (IG), and then check for the current DTC and historic DTC again.
Result:






B -- CLEAR HISTORIC DTC
A -- Continue to next step.
2. CHECK MAYDAY ECU
(a) Press the SERVICES button and check the LEXUS Link condition with the LEXUS Link call center.
OK:
System operates normally.
NG:
System does not connect to LEXUS Link call center (current DTC 2-1 or 2-2 exists).
NG -- REPLACE MAYDAY ECU TOGETHER WITH MAYDAY BATTERY AND THEN PERFORM REGISTRATION
OK -- END