Removal

SUSPENSION: FRONT STABILIZER BAR (for 4WD): REMOVAL

SUSPENSION: FRONT STABILIZER BAR

1. REMOVE ENGINE ASSEMBLY WITH TRANSMISSION
HINT:
Refer to the instructions for removal of the engine assembly (2GR-FSE) Removal.

2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH






(a) Remove the 2 nuts and the front stabilizer link assembly LH.
HINT:
If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH
HINT:
Remove the RH side following the same procedures as with the LH side.

4. REMOVE FRONT STABILIZER NO.2 BRACKET LH






(a) Remove the 2 bolts and the front stabilizer No.2 bracket LH from the front suspension crossmember.
5. REMOVE FRONT STABILIZER NO.2 BRACKET RH
HINT:
Remove the RH side following the same procedures as with the LH side.

6. REMOVE FRONT STABILIZER BAR NO.1 BUSH
(a) Remove the 2 front stabilizer bar No.1 bush from the front stabilizer bar.
7. REMOVE FRONT STABILIZER BAR
(a) Remove the front stabilizer bar from the vehicle.