Installation

SUSPENSION: FRONT STABILIZER BAR (for 4WD): INSTALLATION

SUSPENSION: FRONT STABILIZER BAR

1. INSTALL FRONT STABILIZER BAR






(a) Install the front stabilizer bar to the vehicle.
NOTICE:
The identification mark must be on the right side of the vehicle when installing the front stabilizer bar.

2. INSTALL FRONT STABILIZER BAR NO.1 BUSH






(a) Install the 2 front stabilizer bar No.1 bush outside of the bush stoppers on the front stabilizer bar as shown in the illustration.
NOTICE:
Be sure to install the front stabilizer bar No.1 bush so that the cutouts face the front of the vehicle.

3. INSTALL FRONT STABILIZER NO.2 BRACKET LH






(a) Install the front stabilizer No.2 bracket LH on the vehicle with the 2 bolts.
Torque: 78 Nm (795 kgf-cm, 58 ft-lbf)
4. INSTALL FRONT STABILIZER NO.2 BRACKET RH
HINT:
Install the RH side following the same procedures as with the LH side.

5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH






(a) Install the front stabilizer link assembly LH with the 2 nuts.
Torque: 84 Nm (856 kgf-cm, 62 ft-lbf)
6. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:
Install the RH side following the same procedures as with the LH side.

7. INSTALL ENGINE ASSEMBLY WITH TRANSMISSION
HINT:
Refer to the instructions for installation of the engine assembly (2GR-FSE) Installation.