Removal

PARKING BRAKE: PARKING BRAKE CABLE: REMOVAL

1. DISCONNECT BATTERY NEGATIVE TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY Removal

3. REMOVE FRONT SEAT ASSEMBLY Removal

4. REMOVE CONSOLE UPPER PANEL GARNISH FRONT Removal

5. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal

6. REMOVE INSTRUMENT PANEL FINISH LH PANEL END Removal

7. REMOVE INSTRUMENT PANEL FINISH RH PANEL END Removal

8. REMOVE CONSOLE BOX PLATE (for 4WD) Removal

9. REMOVE CONSOLE BOX REGISTER ASSEMBLY (for 4WD) Removal

10. REMOVE CONSOLE BOX Removal

11. REMOVE FRONT FLOOR BRACE CENTER (for 2GR-FSE) Removal

12. DISCONNECT HEATED OXYGEN SENSOR (for 2GR-FSE) Removal

13. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2GR-FSE) Removal

14. REMOVE FRONT FLOOR HEAT NO.1 INSULATOR (for 2GR-FSE) Removal

15. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 2GR-FSE) Removal

16. REMOVE FRONT FLOOR COVER CENTER LH (for 1UR-FSE)

17. REMOVE FRONT FLOOR COVER CENTER RH (for 1UR-FSE)

18. REMOVE REAR NO. 1 FLOOR PANEL BRACE (for 1UR-FSE) Removal

19. REMOVE FRONT CENTER FLOOR BRACE (for 1UR-FSE) Removal

20. DISCONNECT HEATED OXYGEN SENSOR (for 1UR-FSE) Removal

21. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 1UR-FSE) Removal

22. REMOVE FRONT FLOOR HEAT NO. 1 INSULATOR (for 1UR-FSE) Removal

23. REMOVE AIR GUIDE PLATE OUTSIDE RH (for 1UR-FSE) Removal

24. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 1UR-FSE) Removal

25. REMOVE DIFFERENTIAL SUPPORT NO.2 PROTECTOR Removal

26. REMOVE REAR WHEEL
27. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Disassembly

28. REMOVE REAR DISC Disassembly

29. REMOVE PARKING BRAKE SHOE RETURN NO.2 SPRING Disassembly

30. REMOVE PARKING BRAKE SHOE RETURN NO.1 SPRING Disassembly

31. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET Disassembly

32. REMOVE PARKING BRAKE NO.1 SHOE ASSEMBLY Disassembly

33. REMOVE PARKING BRAKE NO.2 SHOE ASSEMBLY Disassembly

34. REMOVE PARKING BRAKE SHOE LEVER
35. REMOVE PARKING BRAKE NO.3 CABLE ASSEMBLY
(a) Remove the 3 bolts and disengage the 2 clamps and parking brake No.3 cable assembly.
(b) Separate the parking brake No.3 cable assembly from the parking brake equalizer.

(d) Remove the 2 cable support brackets from the parking brake No.3 cable assembly.