Removal

BRAKE MASTER CYLINDER:

REMOVAL
NOTICE:
- The structure of the master cylinder allows the piston to pop out, so observe the following:
1. The master cylinder requires careful handling. Do not allow the master cylinder to receive any impact, such as from being dropped. Do not reuse a master cylinder that has been dropped.
2. Do not scratch or damage the circumference of the piston. For the seal to function correctly, all sliding surfaces must not have any damage.
3. Do not pull out the master cylinder piston.
4. Make sure to release the vacuum from the brake booster (by removing a vacuum hose, etc.) before removing the master cylinder from the brake booster.
5. When installing the master cylinder, remove the protectors for the piston and the discharge port.
6. Apply the supplied grease to the outer diameter of the piston and the inner diameter of the brake booster.

1. DRAIN BRAKE FLUID
NOTICE:
- Stop the engine and depress the brake pedal several times until no vacuum is left in the brake booster.
- If the brake fluid leaks onto any painted surface, wash off and remove the brake fluid completely.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE HOOD HINGE COVER (for LH Side) Removal

4. REMOVE HOOD HINGE COVER (for RH Side) Removal

5. REMOVE ENGINE ROOM SIDE COVER LH Removal

6. REMOVE ENGINE ROOM SIDE COVER RH Removal

7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

8. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
9. REMOVE FRONT SUSPENSION UPPER CENTER BRACE

(a) Remove the 4 nuts and the front suspension upper center brace.
10. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

11. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

12. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

13. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Removal

14. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

(a) Disconnect the connector.

(b) Using SST, disconnect the 6 brake lines and remove the brake master cylinder to way tube.
SST: 09023-00101