Removal

EXTERIOR: REAR BUMPER:

REMOVAL

1. REMOVE REAR BUMPER ASSEMBLY (w/o Intuitive Parking Assist System)






(a) Put protective tape around the rear bumper assembly.






(b) Using a screwdriver, open the 2 rear bumper plates.
HINT: Tape the screwdriver tip before use.





(c) Remove the 2 clips, 4 screws and 2 bolts.






(d) Disengage the 14 claws and disconnect the rear bumper assembly as shown in the illustration.
HINT :
- When disengaging claw A, slide the rear bumper toward the center of the vehicle.
- Use the same procedures for the RH side and LH side.

(e) Remove the rear bumper assembly.
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT (w/ Intuitive Parking Assist System)
3. REMOVE SPARE WHEEL COVER TRAY (w/ Intuitive Parking Assist System)
4. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (w/ Intuitive Parking Assist System) Disassembly

5. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/ Intuitive Parking Assist System) Disassembly

6. REMOVE REAR FLOOR FINISH PLATE (w/ Intuitive Parking Assist System) Disassembly

7. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER RH (w/ Intuitive Parking Assist System) Disassembly

8. REMOVE REAR BUMPER ASSEMBLY (w/ Intuitive Parking Assist System)






(a) Disconnect the connector.
(b) Disengage the grommet.






(c) Put protective tape around the rear bumper assembly.






(d) Using a screwdriver, open the 2 rear bumper plates.
HINT: Tape the screwdriver tip before use.





(e) Remove the 2 clips, 4 screws and 2 bolts.






(f) Disengage the 14 claws and disconnect the rear bumper assembly as shown in the illustration.
HINT :
- When disengaging claw A, slide the rear bumper toward the center of the vehicle.
- Use the same procedures for the RH side and LH side.

(g) Remove the rear bumper assembly.