ABS W/EBD & BA & TRAC & VSC System

DIAGNOSTIC TROUBLE CODE CHART

NOTE: Before replacing or removing the part, turn the ignition switch OFF.

HINT:
- Using SST 09843-18040, connect the terminals Tc and CG of DLC3.
- If any abnormality is not found on inspected parts, inspect the ECU.
- If a malfunction code is displayed during the DTC check, check the circuit indicated by DTC. For details of each code, turn to respective "DTC No." in the DTC chart.

C0200 - C1239:

C1241 - Always ON:

DTC chart of ABS:

*1, *2, *3, *4:
Even after the troubled areas are repaired, ABS warning light will not go OFF unless the following operations are performed.
- *1:
1. Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
2. Clear the DTC.

- *2:
1. Keep the vehicle in the stationary condition for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
2. Drive the vehicle at the vehicle speed 50 km/h (31 mph) and keep depressing the brake pedal strongly for about 3 seconds.
3. Repeat the above operation 3 times or more and check that the ABS warning light goes off.
4. Clear the DTC.

- *3: Depress the brake pedal for 1 sec.
- *4: Depress the brake pedal strongly for 1 sec. then release the brake pedal for 1 sec.

HINT: There is a case that hand-held tester cannot be used when ABS warning light is always on.

C1201 - Always ON:

DTC chart of VSC:

HINT: In some cases hand-held tester cannot be used when VSC warning light is always on.

C1271 - C1277:

C1278 - 1281:

DTC of ABS sensor check function:

C0371:

DTC of VSC sensor check function: