Hazard Warning Switch: Testing and Inspection

1. INSPECT HAZARD WARNING SWITCH CONTINUITY
If continuity is not as specified, replace the switch.







2. INSPECT HAZARD WARNING SWITCH CIRCUIT
Disconnect the switch connector and inspect the connection on the wire harness side.
If the circuit is not as specified inspect the circuits connected to other parts







3. INSPECT TURN SIGNAL SWITCH CONTINUITY
If continuity is not as specified, replace the switch.







4. INSPECT COMBINATION SWITCH CIRCUIT
Connect the wire harness side connector to the combination switch and inspect wire harness side connector from the back side.
If the circuit is not as specified, inspect the circuit connected to other parts.