Installation

REAR SUSPENSION: REAR TRAILING ARM: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL REAR TRAILING ARM ASSEMBLY

(a) Using a jack and wooden block, jack up the rear No. 2 suspension arm assembly to replicate standard vehicle height conditions.





Text in Illustration





NOTICE:
Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

(b) Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts (A) and 2 washers.





Torque : 150 Nm (1530 kgf-cm, 111 ft-lbf)

(c) Install the rear trailing arm assembly to the body with the 2 bolts (B).

Torque : 150 Nm (1530 kgf-cm, 111 ft-lbf)

(d) Slowly lower the rear No. 2 suspension arm assembly.

(e) Install the No. 3 parking brake cable assembly to the rear trailing arm assembly.





Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)

NOTICE:
Do not twist the No. 3 parking brake cable assembly when installing it.

2. INSTALL REAR SPEED SENSOR (for AWD)

(a) Install the rear speed sensor to the rear trailing arm assembly with the bolt.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

NOTICE:
Do not twist the rear speed sensor when installing it.

3. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

4. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Rear Wheel Alignment