Removal

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE FRONT DOOR SCUFF PLATE Removal

4. REMOVE REAR DOOR SCUFF PLATE Removal

5. REMOVE LOWER CENTER PILLAR GARNISH Removal

6. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the bolt and disconnect the floor end of the front seat outer belt assembly.





7. REMOVE CENTER PILLAR GARNISH Removal

8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.





(b) Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.





HINT
Tape the screwdriver tip before use.

(c) Disconnect each connector.

(d) Remove the 2 bolts and front seat outer belt assembly.





9. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

(a) Remove the 2 bolts.





(b) Disengage the guide and remove the front shoulder belt anchor adjuster assembly.