Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION

1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
* Do not replace the spiral cable with the battery connected and the engine switch on (IG).
* Do not rotate the spiral cable with the battery connected and the engine switch on (IG).
* Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
* Do not remove the steering sensor from the spiral cable.

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

(c) Check that the front wheels are facing straight ahead.

(d) Set the turn signal switch to the neutral position.

NOTICE:
If it is not in the neutral position, the turn signal switch pin may snap.

(e) Install the spiral cable with sensor sub-assembly with the 3 claws.





NOTICE:
When replacing the spiral cable with sensor sub-assembly with a new one, remove the lock pin before installing the steering wheel assembly.

(f) Connect the connectors to the spiral cable with sensor sub-assembly.

NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

2. INSTALL UPPER STEERING COLUMN COVER Installation

3. INSTALL LOWER STEERING COLUMN COVER Installation

4. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

5. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Rotate the spiral cable counterclockwise slowly by hand until it stops.





NOTICE:
Do not turn the spiral cable using the airbag wire harness.

(d) Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.





Text in Illustration





NOTICE:
Do not turn the spiral cable using the airbag wire harness.

HINT
The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

6. INSTALL STEERING WHEEL ASSEMBLY Installation

7. INSPECT STEERING WHEEL CENTER POINT

8. INSTALL STEERING PAD Installation

9. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

10. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation

12. INSPECT STEERING PAD Installation

13. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check Reading and Clearing Diagnostic Trouble Codes.

14. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.