Installation

2GR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL ENGINE REAR OIL SEAL

(a) Apply MP grease to a new engine rear oil seal lip.





(b) Using SST and a hammer, tap in the engine rear oil seal.

SST : 09223-15030

SST : 09950-70010

09951-07150

Oil seal tap in depth:

-0.5 to 0.5 mm (-0.0196 to 0.0196 in.)

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

(a) Using SST, hold the crankshaft pulley.





SST : 09213-70011

09213-70020

SST : 09330-00021

(b) Clean the 8 bolts and 8 bolt holes.

(c) Install the front drive plate spacer.





HINT
Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

(d) Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.





(e) Apply adhesive to 2 or 3 threads of the 8 bolts.





Text in Illustration





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(f) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.





Torque : 83 Nm (846 kgf-cm, 61 ft-lbf)

3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)

HINT
See the steps from "Install Automatic Transaxle Assembly" through "Install Engine Assembly with Transaxle" .

4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)

HINT
See the steps from "Install Automatic Transaxle Assembly" through "Install Engine Assembly with Transaxle" Installation.