Removal

AUDIO / VIDEO: RADIO RECEIVER: REMOVAL

1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

3. REMOVE INSTRUMENT PANEL GARNISH LH Removal

4. REMOVE NO. 1 SWITCH HOLE BASE Removal

5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal

6. REMOVE INSTRUMENT PANEL FINISH PANEL Removal

7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL Removal

8. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER

NOTICE:
* The 4 bolts of the radio receiver assembly with register are installed though the service holes at the bottom in the instrument panel. Make sure to check all of them.
* If the radio receiver assembly with register is pulled without removing the 4 bolts, it may result in damage to the radio receiver assembly with register.

(a) Remove the 4 bolts.





(b) Disengage the 9 clips.

(c) Disconnect each connector and remove the radio receiver assembly with register.

9. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY Removal

10. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Disengage the 5 claws and remove the No. 3 instrument panel register assembly.





11. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Disengage the 5 claws and remove the No. 4 instrument panel register assembly.





12. REMOVE RADIO RECEIVER ASSEMBLY