Horn Circuit

THEFT DETERRENT / KEYLESS ENTRY: THEFT DETERRENT SYSTEM: Horn Circuit
- Horn Circuit

DESCRIPTION

When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (multiplex network body ECU) transmits a signal to cause the horn to sound at intervals of 0.4 seconds.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT HORNS

(a) Press the horn switch and check if the horns sound.

Result:





B -- GO TO HORN SYSTEM Symptom Related Diagnostic Procedures
A -- Continue to next step.

2. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

(a) Disconnect the 2F instrument panel junction block assembly and A main body ECU (multiplex network body ECU) connectors.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

OK -- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Removal