Vacuum Brake Booster: Service and Repair

Brake Booster
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

NOTE:
Removal steps in this procedure may contain installation details.

All vehicles
1 Make the SRS system safe.
For additional information, refer to Standard Workshop Practices Standard Workshop Practices
For additional information, refer to Driver Lower Air Bag Module Driver Lower Air Bag Module
For additional information, refer to Windshield Wiper Motor Service and Repair
For additional information, refer to Brake Master Cylinder Service and Repair

Left-hand drive vehicles
For additional information, refer to Battery Tray Service and Repair

Torque to: 10 Nm

WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

CAUTION: Make sure that all openings are sealed. Use new blanking caps.

Torque to: 17 Nm

Right-hand drive vehicles

Torque to: 25 Nm

Installation
1 To install, reverse the removal procedure.