When Ignition Key Is Turned ON (Engine OFF), the ABS Warning Lamp Does Not Light Up.

Detecting Condition






Inspection Procedures
Problem Verification
1. Disconnect the connector from the ABS control module and turn the ignition switch ON.
2. Does the ABS warning lamp light up?






Check the Power Source for the ABS Warning Lamp
1. Disconnect the instrument cluster connector (M03-2) and turn the ignition switch ON.
2. Measure the voltage between terminal (M03-2) 8 of the cluster harness side connector and body ground.

Specification : approximately B+





3. Is voltage within specification?






Check the Can Circuit Resistance for ABS Warning Lamp
1. Disconnect the instrument cluster connector (M03-3) and turn the ignition switch OFF.
2. Measure the resistance between terminal (M03-3) 11 and 12 of the cluster harness side connector.

Specification : 60Ohms





3. Is resistance within specification?






Check the Can Circuit Wiring for ABS Warning Lamp
1. Disconnect the instrument cluster connector (M03-3) and ABS HECU connector, and then turn the ignition switch OFF.
2. Check for continuity between terminal (M03-3) 12 of the cluster harness side connector and terminal 6 of ABS HECU harness side.
Check for continuity between terminal (M03-3) 11 of the cluster harness side connector and terminal 13 of ABS HECU harness side.

Specification : Below 1Ohms


3. Is resistance within specification?