Steering Gear - Installation

INSTALLATION

CAUTION: Steering column module is centered to the vehicles steering system. Failure to keep the system and steering column module centered and locked/inhibited from rotating can result in steering column module damage. Procedures .





1. Install the outer tie rod ends. (if removed).
2. Position the steering gear back into the vehicle the same way it was removed.





3. Install the steering gear mounting nuts (2) and tighten to 244 Nm (180 ft. lbs.). After tightening the nuts, re-center the steering gear (1).





4. 8 Cylinder engine only - Install the pressure and return lines (2, 3) to the steering gear (1) and tighten to 28 Nm (21 ft. lbs.).
5. 4x4 ONLY - Install the front axle Installation or Installation.
6. Install the front splash shield (if removed).
7. If equipped, install the front skid plate.





8. Install the oil filter drip tray (1).





9. Install the outer tie rod ends (2) to the knuckles (5) and tighten the tie rod end nuts (1) to 95 Nm (70 ft. lbs.).
10. Install the wheel and tire assembly, Removal and Replacement.
11. Remove the support and lower the vehicle.





12. 6 Cylinder engine only - Install the pressure and return hoses (2, 3) to the steering gear (1) and tighten to 28 Nm (21 ft. lbs.).






CAUTION: The steering gear must be centered prior to installing the coupler to prevent clockspring damage.

13. Install the column coupler shaft into the lower coupling (1), install a new bolt (2), and tighten to 49 Nm (36 ft. lbs.).
14. Remove the steering wheel lock.
15. Fill the power steering pump Power Steering System Bleeding.
16. Set the toe. Service and Repair.