Installation

INSTALLATION










1. Install the park brake shoes (1) onto the actuator lever (2).
2. Install shoes on support plate with hold down clips and pins (4). Be sure shoes are properly engaged in the park brake actuator lever (2).
3. Install the return spring (3).
4. Lubricate and install adjuster screw assembly (5). Be sure notched ends of screw assembly are properly seated on shoes and that star wheel is aligned with access hole in the support plate.
5. Install shoe to shoe adjuster spring (6). Needle nose pliers can be used to connect spring to each shoe.





6. Install the axle shaft (1) to the rear differential Installation.





7. Install and tighten the axle flange nuts (1).










8. Install rotor to the axle hub.










9. Install the caliper and the 2 mounting bolts (4) to 44 Nm (32 ft. lbs.).










10. Adjust the parking brake shoes.
11. Install wheel and tire assembly.
12. Lower vehicle and verify correct parking brake operation.