Rear Bumper Fascia - Installation

INSTALLATION





1. Install the park assist sensors, if equipped.
2. Install the energy absorber and install the four push pin fasteners.
3. Position the fascia onto the vehicle and connect the electrical connectors (7).





4. Install the two push pin fasteners (3).





5. Slightly spread the sides of the fascia to clear the painted surfaces.
6. Direct the slots in the upper sides of the fascia onto the two T-pushpins (4) on either side.
7. Install the two screws (2) and four push pin fasteners (1).





8. Position the rear quarter panel flare onto the rear fascia and quarter panel and seat the clips fully, using the sequence shown in the illustration (A - G).
9. Install the rivets securing the wheel liner to the flare using the sequence shown (1 - 6).