Supercharger: Service and Repair

Removal
1. Disconnect battery ground cable.
2. Drain radiator coolant.
3. Remove air cleaner cover / intake assembly.
4. Remove throttle body.
5. Remove exhaust gas recirculation valve (EGR) if installed.
6. Remove throttle intake elbow.
7. Remove supercharger outlet duct.
8. Remove coolant outlet pipe.
9. Remove supercharger drive belt. Service and Repair
10. Disconnect remaining coolant hoses from charge air coolers.
Position pipes to facilitate removal of supercharger.
Install suitable blanking plugs.





11. Remove supercharger from engine.
1. Remove bolt.
2. Remove bolts.
3. Remove supercharger.


Installation
1. Install supercharger. Tighten bolts (1 and 2) to 18 - 24 Nm.
2. Connect all hoses to charge air coolers.
3. Install supercharger drive belt.
4. Install engine coolant outlet pipe.
5. Install supercharger outlet duct and new gasket.
6. Install throttle intake elbow.
7. Install exhaust gas recirculation valve (EGR) if applicable.
8. Install throttle body.
9. Install air cleaner cover / intake assembly.
10. Refill cooling system.