Centre Console Veneer Panel

CENTRE CONSOLE VENEER PANEL

Removal
1. Apply handbrake and turn ignition key to II.
2. Depress brake pedal, move gear selector to position N and turn ignition key to O.
3. Remove battery cover and disconnect cable from earth terminal.
4. Remove 'J' gate finisher. 'J' Gate Finisher







5. Slacken and remove the two nuts and two screws securing the retaining panel.







6. Position retaining panel for access, disconnect SPORT mode and cruise control ON/OFF switch multiplugs and remove retaining panel complete with switches.







7. Remove and discard bushes from retaining plate.







8. Carefully withdraw veneer panel, releasing front locating tongue from upper slot in console.

Installation
1. Position veneer panel on console, ensuring that front tongue locates correctly in console upper slot.
2. Fit and fully seat new bushes in retaining panel.
3. Position retaining panel complete with SPORT mode and cruise control ON/OFF switches for access and connect multiplugs.
4. fully seat retaining panel and fit and tighten securing nuts and screws.
5. Fit 'J' gate surround finisher. 'J' Gate Finisher
6. Move gear selector to position P.
7. Connect cable to battery earth terminal and fit battery cover.