B1478

Circuit Description
The retained accessory power function allows certain systems to operate for 20 minutes after the ignition switch is turned to the OFF position. Examples of systems that retain power include the following systems:
- The radio
- The power windows

The BCM monitors the following items:
- The ignition switch position
- The voltage on CKT 755

The BCM will command the RAP relay to turn on by grounding CKT 755 when the following conditions exist:
- All of the doors are closed.
- The ignition switch is in the OFF position.

DTC B1478 will set if the following conditions exist:
- The BCM detects an open or a short to battery in CKT 755.
- The RAP relay is commanded ON.

Conditions for Setting the DTC
- The BCM detects battery voltage on CKT 755 (short to battery) with the ignition switch in the RUN position.
- The system voltage is between 9.0 - 16.0 volts.
- The above conditions exist for 0.5 seconds.

Action Taken When the DTC Sets
The following items will not operate after the ignition switch is turned OFF and all of the doors are closed:
- The radio
- The power windows

Conditions for Clearing the MIL/DTC
- DTC B1478 will clear immediately when one of the following actions occurs:
- The condition that sets the fault is corrected with the ignition in the RUN position.
- The next ignition cycle starts.
- A history DTC will clear after 100 consecutive ignition cycles without a fault present.
- History and current DTCs may be cleared using a scan tool.

Diagnostic Aids
- Always diagnose the first current DTC that is listed on the scan tool.
- Verify that the scan tool displays DTC B1478 as a current code before you perform diagnostics
- Inspect the wiring, terminals, and connectors for loose or poor connections at all of the related components.
- Refer to Intermittents and Poor Connections Diagnosis in Overall Vehicle Information / Testing and Inspection.

Steps 1 - 3:

Steps 4 - 7:

Test Description
The numbers below refer to the step numbers on the diagnostic table.
2. This step determines if the RAP relay coil is shorted.
3. This step determines if one of the following conditions exists:
- CKT 755 (BLK) is shorted to battery.
- The BCM is shorted internally.