Windshield Washer Spray Nozzle: Testing and Inspection

FRONT WASHER NOZZLE AND TUBE

Inspection and Adjustment


INSPECTION

Washer Nozzle Inspection





Check that air can pass through the hose by blowing forward (toward the nozzle), and check that air cannot pass through by sucking.

ADJUSTMENT

Washer Nozzle Spray Position Adjustment
Adjust spray positions to match the positions shown in the figure below.
NOTE:
This figure is for LHD models and is symmetric with RHD models.










Unit: mm (in)





Check that washer fluid is splayed on 80% or more the splay area () when spraying washer fluid. If the spray area deviates from the specification, adjust the washer nozzle.

CAUTION:





- Use washer nozzle adjuster* (A) for nozzle adjustment.
- Never use needle or small pin.
*: Washer nozzle adjuster is included with shipment of nozzle.
NOTE:
If wax or dust gets into the nozzle, remove wax or dust with a needle or small pin.