Removal and Installation

FRONT SUSPENSION MEMBER

Removal and Installation


REMOVAL

1.At first, remove engine and transmission assembly with front suspension member downward. Then separate engine, transmission assembly and front suspension member. Refer to "Exploded View" Exploded View.
2.Remove the following parts.
- Steering knuckles and wheel hub and bearing assemblies. Refer to "Exploded View" Exploded View.
- Steering gear assembly and hydraulic line. Refer to "Exploded View" Exploded View and "Exploded
View".
- Stabilizer bar and stabilizer connecting rods. Refer to "Exploded View" Exploded View.
- Transverse links. Refer to "Exploded View" Exploded View.
- Remove suspension member stay.
- Remove suspension member sub stays.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Perform final tightening of bolts and nuts at the vehicle installation position (rubber bushing), under unladen condition with tires on level ground.