Diagnosis Procedure

SLIDING SWITCH

PASSENGER SIDE : Diagnosis Procedure


1. CHECK SLIDING SWITCH SIGNAL

1.Turn ignition switch OFF.
2.Check voltage between passenger seat control unit harness connector and ground.





Is the inspection result normal?
YES- Sliding switch circuit is OK.
NO- GO TO 2.

2. CHECK SLIDING SWITCH INPUT SIGNAL

1.Disconnect power seat switch connector.
2.Check voltage between power seat switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 4.
NO- GO TO 3.

3. CHECK SLIDING SWITCH CIRCUIT

1.Disconnect sliding switch (seatback) connector.
2.Check continuity between sliding switch (seatback) harness connector and power seat switch harness connector.





3.Check continuity between sliding switch (seatback) harness connector and ground.





Is the inspection result normal?
YES- GO TO 5.
NO- Repair or replace harness.

4. CHECK SLIDING SWITCH

Check sliding switch.
Refer to "PASSENGER SIDE : Component Inspection" Component Inspection.
Is the inspection result normal?
YES- GO TO 6.
NO- Replace power seat switch. Refer to "Removal and Installation" Power Seat Switch.

5. CHECK SLIDING SWITCH (SEATBACK)

Check sliding switch (seatback).
Refer to "SEATBACK : Component Inspection" Component Inspection.
Is the inspection result normal?
YES- GO TO 6.
NO- Replace sliding switch (seatback). Refer to "Exploded View" Exploded View.

6. CHECK INTERMITTENT INCIDENT

Check intermittent incident.
Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END