Procedures

RETRACTABLE HARD ROOF ASSEMBLY

Manual Operation


CAUTION:
- Protect the rear fender with a fender protector.
- Take all precaution to avoid any interference between the retractable hard top and the body.

CLOSE STATE TO OPEN STATE

1.Remove metal clip from front roof garnish rear end. Insert a hexagon wrench through clearance between headlining. Rotate roof latch motor shaft using the hexagon wrench and then unlock roof lock assembly.

CAUTION:
Be careful not to deform front roof garnish.
2.Remove rear parcel shelf finisher board from trunk room side. Refer to "REAR PARCEL SHELF UNIT : Removal and Installation" Removal and Installation.
3.Remove TORX bolt from rear parcel shelf unit linkage. Check that rear parcel shelf board mounting bracket moves freely while not interfering with other components.
4.Remove trunk room trim, and then open hydraulic unit valve.





CAUTION:
Check that valve opening torque is always with in the specified value for preventing oil leakage.
5.Remove trunk lid assembly. Refer to "TRUNK LID ASSEMBLY : Removal and Installation" Removal and Installation.
6.Pry roof link and unlock roof lock.
7.Open roof by manually.

CAUTION:
- This operation requires two people.
- Keep hands away from the moving parts.

OPEN STATE TO CLOSE STATE

1.Remove seat cushion and seatback. Refer to "Removal and Installation" Removal and Installation.
2.Remove rear side finisher. Refer to "Removal and Installation" Removal and Installation.
3.Remove TORX bolt from rear parcel shelf unit linkage. Check that rear parcel shelf board mounting bracket moves freely while not interfering with other components.
4.Remove rear parcel shelf finisher board. Refer to "REAR PARCEL SHELF UNIT : Removal and Installation" Removal and Installation.
5.Remove trunk lid assembly. Refer to "TRUNK LID ASSEMBLY : Removal and Installation" Removal and Installation.
6.Remove trunk lid drive cylinder upper side pin. Refer to "Removal and Installation" Removal and Installation.
7.Lift up trunk hinge.
8.Remove front roof garnish. Rotate roof latch motor shaft using the hexagon wrench and then unlock roof lock assembly.
9.Remove roof drive cylinder front side pin. Refer to "Removal and Installation" Removal and Installation.

CAUTION:
Wait until tension on roof drive cylinder after roof operation is released.
10.Close roof by manually.

CAUTION:
- This operation requires two people.
- Keep hands away from the moving parts.
11.Remove trunk room trim, and then open hydraulic unit valve.





CAUTION:
Check that valve opening torque is always with in the specified value for preventing oil leakage.