Disassembly and Assembly

DOOR MIRROR

GLASS MIRROR : Disassembly and Assembly


DISASSEMBLY

1.Remove the pawls and disassemble the base cover.
2.Place the glass mirror upward.
3.Put a strip of protective tape (B) on housing assembly.
4.As shown in the figure, insert a small flat-bladed screwdriver (A) into the recess between glass mirror (1)
and actuator (2). Push up two pawls (3) to remove glass mirror lower half side.
NOTE:
- When pushing up pawls do not attempt to use one recess only. Be sure to push up with both recesses.
- Insert a small flat-bladed screwdriver into recesses, and push up while rotating (twisting) to make work easier.





5.Remove both terminals of mirror heater attachment.
6.Lightly lift up lower side of glass mirror, and detach two pawls of upper side as if pulling it out. Disassemble glass mirror from actuator.
NOTE:
Be certain not to allow grease on sealing agent in center of mirror or back side of glass mirror.

ASSEMBLY

Assemble in the reverse order of disassemble.

CAUTION:
After installation, visually check that pawls are securely engaged.