Removal and Installation

HEADLINING

Removal and Installation


REMOVAL

1.Remove body side welt (LH/RH) and front pillar garnish (LH/RH). Refer to "Removal and Installation" Removal and Installation.
2.Remove sunvisor assembly (LH/RH).
- Remove sunvisor cover.
- Remove sunvisor assembly fixing screws.
- Disconnect vanity mirror lamp harness connectors.





3.Insert small flat-bladed screwdriver into the hole of sunvisor holder, press while rotating approximately 90 degrees to remove.
4.Remove map lamp assembly.





- Insert remover tool between map lamp assembly and roof front finisher assembly to disengage the fixing pawls and metal clips.
- Disconnect map lamp harness connector.
- Remove map lamp assembly.





5.Remove the roof front finisher mounting bolt.





6.Remove roof front finisher as shown in the figure.

CAUTION:
Never bend roof front finisher when removing.
7.Remove map lamp bracket after removing roof front finisher.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
Never bend roof front finisher when installing.