Inspection

LOWER SHAFT

WITH 4WAS : Inspection and Adjustment


ADJUSTMENT BEFORE REMOVAL

Adjust neutral position of 4WAS front actuator. Work Procedure (Pattern 1).

INSPECTION AFTER REMOVAL






- Check the sliding range of the lower shaft (with 4WAS front actuator).

CAUTION:
Check the sliding range (A) (between the extended position and the contracted position) of the lower shaft (with 4WAS
front actuator).


Sliding range: Lower Shaft Sliding Range.
- Check each part of lower shaft (4WAS front actuator) for damage or other malfunctions. Replace if there are.

INSPECTION AFTER INSTALLATION

- Check if steering wheel turns smoothly when it is turned several times fully to the end of the left and right.
- Check the steering wheel play, neutral position steering wheel, steering wheel turning torque, and front wheel turning angle. Inspection.
- Adjust neutral position of 4WAS front actuator. Work Procedure (Pattern 2).