Base Audio

AV CONTROL UNIT

Removal and Installation


REMOVAL


CAUTION:
- Before replacing AV control unit, perform "READ CONFIGURATION" to save or print current vehicle specification. For details, Base Audio.
- Remove battery terminal and AV control unit after a lapse of 30 seconds or more after turning the ignition switch OFF.
NOTE:
After the ignition switch is turned OFF, the AV control unit continues operating for approximately 30 seconds.
Therefore, data corruption may occur if battery voltage is cut off within 30 seconds.
1.Remove the preset switch. Base Audio.
2.After removing the AV control unit mounting screws to disconnect the connectors, remove the AV control unit with the bracket attached.
3.Remove the bracket screws to remove the bracket from the AV control unit.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
Be sure to perform "WRITE CONFIGURATION" when replacing AV control unit. For details, Base Audio.