Removal And Installation

FRONT COMBINATION LAMP

Removal and Installation


REMOVAL


CAUTION:
Disconnect the battery negative terminal or remove the fuse.
1.Remove the front bumper fascia. Removal And Installation.
2.Remove the washer inlet tube.
3.Remove the headlamp mounting bolts and clips.
*





4.Remove the harness clip and the holding clip (A).
*: Left side only.





5.Pull out the headlamp assembly forward the vehicle, and then disconnect the connector before removing the headlamp assembly.

INSTALLATION

Note the following item and then, install in the reverse order of removal.
NOTE:
After installation, perform aiming adjustment. Description.