Removal and Installation

PARKING BRAKE CONTROL

Removal and Installation


REMOVAL

1.Remove rear tires with power tool.
2.Remove instrument lower panel LH. Removal And Installation.
3.Disconnect parking brake switch harness connector.
4.Remove adjusting nut and loosen front cable.
5.Remove parking brake pedal assembly.
6.Remove center console. Removal And Installation.
7.Remove the center muffler and heat insulator. Removal And Installation
(VQ-37VHR), Removal And Installation (VK-56VD).
8.Separate front cable from rear cable, and remove front cable and spring.
9.Remove parking brake shoe, and remove rear cable from toggle lever. Removal and Installation.
10.Remove rear cable mounting bolts and nuts, pull out rear cable from vehicle.

INSTALLATION

Note the following, Install the reverse order of the removal.
- Never reuse the adjusting nut.
- Perform adjustment after installation. Adjustments.