Removal And Installation

REAR BUMPER

Removal and Installation


REMOVAL


CAUTION:
Bumper fascia is made of resin. Never apply strong force to it, and be careful to prevent contact with oil.
1.Fully open trunk lid.
2.Remove rear combination lamp (LH and RH). Removal And Installation.





3.Remove fixing clips (A) and screws (B) (LH and RH).
4.Remove bolt and clip of bumper fascia underside.





5.Remove bumper fascia both ends fixing screws (A) (LH and
RH).
6.Pull bumper fascia side toward the vehicle side to disengage the fitting of bumper side bracket and bumper fascia side.

CAUTION:
When removing bumper fascia, 2 workers are required so as to prevent it from dropping.
7.Remove bumper energy absorber.
8.Remove bumper reinforcement fixing nuts, and then remove bumper reinforcement.

INSTALLATION

Install in the reverse order of removal.
NOTE:





After installing, perform fitting adjustment.